I was having trouble because I connected PB0 to the bottom of the RX LED, instead of the bottom of the resistor below the RX LED! Oops, my mistake, I described where to solder wrong. Glad you got that working The remaining issue is the calibration is off and the button initially seem slow to be ...

Not sure if you can really call what I did an idea, it's really just 'take what others have done and make it smaller'. The only reason I needed both PB0 and PD0 was because I was using the 3DPro32u4-10 firmware. I may have misunderstood the details, but I think sw3dprousb originally used port D and ...

Not sure if it's bad form replying to myself, but I just wanted to follow up on my last post. I wanted to see if I could fit the adapter in to a small case . InCase.jpg The Arduino Micro I'd used before was too long, so I figured the Sparkfun ProMicro (or equivalent) might be small enough. The only ...

This was fun, just got a SideWinder 3D Pro Plus (97462) working again. Thanks to all involved in putting this together, thought I should make a note of what I got working. I had an Arduino Micro to hand, so I've used a USBASP to load it with the 3DPro32u4-10.hex firmware. The connector on the ...